Coffee from your machine tastes off? Sour, bitter, watery — what to change

Before you decide the machine is broken, check the settings. Most often changing one thing is enough. Below: what each taste means and what to do about it.

Bean-to-cup machine: what to adjust

Sour

  • Cold cup — warm it with hot water or keep it on the cup warmer
  • Brewing temperature too low — set it higher in the menu
  • Grind too coarse — go finer
  • Too little coffee per shot — raise the strength
  • Too much water for one shot — make two shots
  • First coffee after switching on — rinse the machine first

Bitter

  • Grind too fine — go coarser
  • Temperature too high — lower it by one step
  • A long coffee from a single shot — make two shots
  • Dirty brew unit — take it out and rinse it

Watery

  • Too little coffee — raise the strength
  • Too much water in the cup — reduce the volume
  • Grind too coarse — go finer

What went wrong?

Change one thing at a time, grind first.

Sour, sharp, thin

Under-extracted — the water passed through too quickly.

  • Grind finer
  • Use hotter water
  • Extend the brewing time
  • Check the coffee is not too fresh (less than a week from roasting)
  • Warm the cup — in a cold cup coffee cools fast and tastes more sour

Bitter, dry, astringent

Over-extracted — the water stayed too long or was too hot.

  • Grind coarser
  • Lower the temperature by 2–3 °C
  • Shorten the time
  • Clean the equipment

Watery, weak

Too little coffee or the grind is too coarse.

  • Add coffee (more grams per millilitre)
  • Grind finer
  • Use a scale, not spoons

Strong but unpleasant

Plenty of coffee, but it extracts unevenly.

  • Reduce the dose
  • Grind evenly (burr grinder)
  • Do not stir during brewing unless the method calls for it

When it is already a fault

  • The taste changed suddenly while the beans and settings stayed the same
  • Coffee drips or flows very slowly even on a coarser grind
  • Coffee is lukewarm although the cup is warmed
  • The puck is wet and smeared instead of a firm tablet
  • Changing the grind setting makes no difference

That is usually a dirty brew unit, limescale, a worn grinder or a weak pump. We will check — diagnostics for home machines are free.

See also

Prepared together with Octava Coffee Roasters, Warsaw.

Tell us what's wrong with your machine — we'll call you back or send an SMS, advise and arrange the drop-off. Diagnosis is free.

Request a repair

Request